Integrated walkway is a low maintenance system with a 99 year design lifetime. The aluminum construction will not rust, and there is no need to paint it as would be required with steel. The decking has a minimum bending radius of 400m to smoothly follow transit lines. The decking also covers all process lines to keep them fully out of sight.

You can always rely on Integrated Walkway, even under extreme conditions. Seismic bracing and expansion joints are fundamental design features. All systems are fully grounded and bonded. Solid top covers are used in case of fire or flame over. And the decking tread grip has passed slip resistance tests with a rating of BPN 55.

VANCOUVER’S CANADA LINE RAPID TRANSIT
The Canada Line is an automated rail-based transit service running from Downtown Vancouver with service to Vancouver International Airport. We designed and supplied approximately 19km of maintenance Integrated Walkways for the elevated and at-grade segments of the Canada Line Rapid Transit Project. This design not only minimized material costs but also was light, durable and simple to install, further reducing costs by drastically saving on labour.

Embedded support channels in the trench are supplied and allow for easy cable bus installation. Trench covers provide convenient access for future expansion.

Econo Bus Dry Seal can be used anywhere a water and dust tight seal is required. The components can be mixed and matched to suit your needs. And everything is available off the shelf with zero lead time.

Mount plates come in a wide range of sizes. They ship pre drilled and tapped. Seals and gaskets made of injection moulded rubber are available for all common cable diameters. There is no sealant required and no drying time.

Meeting electrical code requirements is a must, and it has never been more straightforward than with Econo Bus. Short circuit bracing, proper phase arrangement, and adequate ventilation are all fundamental features of the design.

Made of a fire-rated material which is sunlight resistant, Econo Bus is suitable for installation in the toughest environments. Peace of mind for you, and your clients, all at a minimal cost.

Econo Bus is a simple and rapid method of supporting power cables. It can be wall mounted, installed in cable tray, and mounted directly to unistrut. Never strap down individual cables again. Econo bus is faster to install, and will not damage cable insulation in a short circuit event. Extra rows of cables can be stacked vertically, allowing for the possibility of future expansion. At the same time, Econo Bus is able to maintain the spacing requirements for free air ventilation.