Cable Tray Suspension Channels and Fittings

• Center Supports
• Hanger Rods
• Channel Tray Supports
• Angles

Cable Tray Center Support

Center Supports provide an economically-friendly support structure for cable trays carrying light to medium loads. The center support utilizes reduced materials as compared to other support structures and affords easier access to both sides of a cable tray system. However, due dilligance should be given to balance the loads during cable installation. Center Supports are supplied with support channels, hanger rod sleeves, nuts, washers, hold down clips and the applicable hardware.
1/2" hanger rods are not included.

Maximum allowable load is 800 lbs. with 1.5 safety factor.

Hanger Rods

Hanger rods with 1/2" diameter and 13 threads per inch can be used with all cable tray support channels, angles and hanger clips. They have continuous threads and are furnished with 4 (N-12) nuts, 2 (W-9) lock-washers and 2 (W-12) flat washers.

Maximum allowable load:
The design loading of hanger rods is 1100 lbs, where installed with all standard suspension fittings, hanger clips, and couplings, however, the safe loading value is much higher.

Channel Supports

Channel supports are used with 1/2" hanger rods to support ladder style cable trays where hanger clips cannot be utilized and for troughs with or without hold-down clips. When used with trough, only HB-2, JB-2, etc. style hold-down clips can be used.

Angles

Angles are continuously slotted to hold down troughs using HB-1 bolts, and can be used to support all cable tray types with 1/2" hanger rod suspended from overhead.

Maximum allowable load:
It safely supports any loaded tray of the designated width within the load limits of the hanger rod.

Suspension Channels and Fittings Hangers Vertical Run Supports Brackets, Struts and Strut Hardware