Cable Tray Accessories
Cable Tray End Drop-Out
This dropout is used at the end of a cable tray system, or to provide a smooth drop off for small cables at any point between the rungs of a ladder tray system. It is used in pairs, where dropping cable from both directions, or singularly, when dropping cables in only one direction.
Cable Tray Conduit Side Drop-Out
This type of dropout is a bracket used to secure a conduit clamp (not included), to the side rail of the tray, allowing cables to exit the tray into conduit drops to the equipment.
Grounding Connectors for Cable Tray
Type GC Connectors hold a single through cable and a tap cable while separating the ground conductor from the cable tray surface. Note that the bolt head is mounted on the inside wall of the cable tray to avoid damage to the cable insulation. Grounding connectors may be used with aluminum or galvanized steel cable trays. When mounted horizontally, the bolt may be used to replace one of the bolts in a splice plate.
Grounding Clamps for Cable Tray
Type GBM Clamps hold a single through cable directly on the cable tray surface.
Mini Trim
Mini trim can be used as a protective edging to protect
cables from sharp surfaces that cables may contact.
Mini trim is a vinyl embossed extrusion with a
segmented metal core that can be cut with a knife
between the metal core segments. It will grip edges
from .010" to .050" thick, and is supplied in 100 ft. rolls
in black.
Catalog Number: Mini Trim
Cable Separators
Cable separators (divider strips) are available for all
tray types in aluminum, mill galvanized and 304 or 316
stainless steel. Separators come in either 3? or 5?
heights and are slotted at regular intervals for ease of
installation without field drilling. Separator Rung
Fasteners must be ordered separately for attachment to
Tray rungs without drilling.
Vertical separators must be factory formed to the
proper radius needed. Vertical separators can be
ordered to the degree of bend or the customer can
order all 90 degree separators and field cut them to the proper
degree bends.
Cable Separator for Staight Length
StchannelInto.htmlard length is 12 feet. The grouping of slots is designed to fit the hole-pattern of ventilated Tray.
Cable Separator for Horizontal Bends
Standard length is 6 feet. Each piece is punched channelInto.html slotted for easy field adjustment to any degree of radius curvature. Sections may be field cut or continued along a straight run.
Cable Separator for Vertical Bends
The following information is required while ordering:
- Inside or outside bend
- Degree of bend
- Radius of bend
Cable Separator Fasteners for Cable Tray
Separator fasteners allow attachment of separators to Tray rungs without drilling the rungs. These fasteners are required 4 per straight section, 3 per horizontal fitting and 2 per vertical fitting. Rung fasteners are stainless steel.
Cable Seperator Splices
Hold Down Clips, Expansion Guides, Splices and Connections Accessories
